Kia Sorento: TPMS Sensor Description

|
1. |
Mode
|
(1) |
Configuration State
| A. |
All sensors should be in the Low Line state.
|
| B. |
In Low Line configuration, sensor transmissions
occur every 1 minute (nominal) and pressure is measured
every 4 seconds.
|
|
|
(2) |
Normal Delayed Auto State
| A. |
This is Low Line specific and is used for all
HMC/KMC High Line applications.
|
| B. |
In this state, the sensor will transmit for approx.
12 minutes before automatically entering storage state.
|
|
|
(3) |
Storage Auto State
| A. |
This state is a Low quiescent current state.
|
|
2) |
The sensor does not measure pressure /
temperature / battery level.
|
|
3) |
The sensor will not transmit, unless requested
to do so by the initiate command.
|
|
|
|
(4) |
Alert State
| A. |
The sensor automatically enters this state if
the measured temperature exceeds 110°C and over temperature
shutdown is likely.
|
| B. |
In this state, pressure is measured every 4 seconds
and RF data transmitted every 4 seconds.
|
| C. |
The state lasts for 1 minute if it is pressure
triggered.
|
|
|
Tread Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire pressure is below a ...
Tire Removal
1.
Deflate tire & remove balance weights.
...
See also:
[CVVT System Mode]
(1) Low Speed / Low Load
(2) Part Load
(3) Low Speed / High Load
(4) High Speed / High Load
...
Rear Glass Defogger Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
...
Owner maintenance
The following lists are vehicle checks and inspections that should be performed
by the owner or an authorized Kia dealer at the frequencies indicated to help ensure
safe, dependable operation of you ...