Kia Sorento: Side Body C - Body Dimensions - Body (Interior and Exterior) - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Side Body C

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body (Interior and Exterior) / Body Dimensions / Side Body C

* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]

Front side member tooling hole (Ø8.2)

Fender apron upper panel tooling hole (Ø8)
Front door upper hinge mounting hole
(Ø13)

Front door lower hinge mounting hole
(Ø13)
Fender panel mounting hole (Ø6.6)

Side outer panel notch

Side outer panel notch

Side outer panel notch

Front door switch mounting hole (Ø10)

Rear door upper hinge mounting hole
(Ø13)
Rear door lower hinge mounting hole
(Ø13)
Side outer panel notch


Side outer panel notch

Quarter fixed glass mounting hole
(Ø6)
Rear door switch mounting hole (Ø10)

Side sill moulding mounting hole
(12X12)
Quarter fixed glass mounting notch

Rear bumper mounting hole (Ø12)


Side Body B
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Interior A
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

See also:

Air Ventilation Seat Installation
1. Install the blower fan. 2. Install the seat back and cushion. ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose. (Re ...

Smart key unit Components
Connector Pin Information No. Connector A Connector B Connector C 1 V_BAT load C_CAN Low SSB illumination ground 2 ...

Copyright © www.ksmanual.com 2014-2019