Kia Sorento: In-car Sensor (DATC only) Description - Air conditioning System - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2020 Service ManualKia Sorento: In-car Sensor (DATC only) Description

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / In-car Sensor (DATC only) Description

An in-car air temperature sensor is located in the crash pad lower panel.
The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signal the control unit regulates the in-car temperature to the intended value.

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") ...

In-car Sensor Inspection
1. Turn the ignition switch ON. 2. Blow air with changing temperature into the in-car sensor air inlet. Measure the sensor resistance betwe ...

See also:

Component Location
1. Start relay #2 (W/O immo./smart key) / ACC relay (With smart key) 2. Start relay #1 3. Windshield deicer relay 4. Power outlet relay 5. Wiper relay (low) 6. Burgla ...

Front Fog Lamps Installation
1. Install the front fog lamp bulb. 2. Connect the fog lamp connector. 3. Install the front tire wheel guard. ...

Rear Bumper Components
1. Rear bumper cover 2. Rear bumper lower bracket [RH] 3. Rear bumper lower bracket [LH] 4. Rear bumper side bracket [RH] 5. Rear bumper side bracket [LH] ...

Copyright © www.ksmanual.com 2014-2020