1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
|
3. |
Remove the heater unit lower case (A) after loosening the mounting
screws.
|
4. |
Remove the evaporator sensor (A).
|
5. |
Install in the reverse order of removal.
|
Front Body C
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Fuel Pump Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
...
Components Location
1. Automatic transaxle
2. Shift cable bracket
3. Inhibitor switch connector
4. Manual control lever
5. Automatic transaxle mounting support bracket
6. Solenoid valve conne ...