Kia Sorento: Audio Unit Removal - Audio - Body Electrical System - Kia Sorento XM 2011-2020 Service ManualKia Sorento: Audio Unit Removal

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / Body Electrical System / Audio / Audio Unit Removal

  
Put on gloves to protect your hands.
  
Х
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Х
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Х
Take care not to bend or scratch the trim and panels.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")

3.
Disconnect the connectors and cables (A) from center fascia panel.

4.
Remove the crash pad center air vent (A).

5.
Remove the audio head unit (A) from crash pad after loosening the screws (4EA).

6.
Disconnect the connectors and cables (A) from head unit.

  
When the compact disc is not ejected, do not remove it forcibly.
Audio Unit Components
Connector Pin Information No Connector A Connector B 1 Rear left speaker (+) CAN high 2 Front left speaker (+) - ...

Audio Unit Installation
1. Connect the audio unit connectors and cable. 2. Install the audio unit. 3. Install the center facia panel. ...

See also:

In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS)
Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

Ignition Coil Removal
1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connec ...

Copyright © www.ksmanual.com 2014-2020