Kia Sorento: Shift Lever Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Shift Lever Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Removal

1.
Remove the floor console.
(Refer to Body - "Floor console")
2.
Remove the air duct.
3.
Disconnect the sports mode connector (A).

4.
Disconnect the shift cable (A).

5.
Remove the shift lever assembly (A) by removing the bolts (C-4ea).

Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Shift Lever Components
1. Shift lever mounting bolt 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Lever Installation
1. Install in the reverse order of removal.    Set shift lever and inhibitor ...

See also:

Smart Key Diagnostic Inspection
Self Diagnosis With GDS Smart key system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. The following thr ...

SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Fuel Pressure Test (Low pressure system)
1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...

Copyright www.ksmanual.com 2014-2026