Kia Sorento: Cargo Lamp Installation - Lighting System - Body Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Cargo Lamp Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body Electrical System / Lighting System / Cargo Lamp Installation

1.
Replace the lamp bulb.
2.
Install the cargo lamp assembly after connecting the lamp connector.
Cargo Lamp Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the cargo lamp lens (A) with a flat-tip screwdriver. 3. ...

Rear combination lamp Removal
1. Disconnect the negative (-) battery terminal. [Outside] 2. Loose the screws (2EA) holding the rear combination lamp then disconn ...

See also:

Description
Burglar Alarm State [B/A State] B/A State Description DISARM 1. In "DISARM" state, no vehicle start inhibition. So, whe ...

Smart Key
Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. ...

Transaxle Control Module (TCM) Removal
   When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Copyright © www.ksmanual.com 2014-2019