Kia Optima Manuals

Kia Sorento: Inspection - Inhibitor Switch - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch / Inspection

  
•
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Power Circuit Inspection
1.
Disconnect the Inhibitor swtich connector.
2.
Ignition KEY "ON"" & Engine "OFF".
3.
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Signal Circuit Inspection
1.
Connect the Inhibitor switch connector.
2.
Ignition KEY "ON" & Engine "OFF".
3.
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
Signal Code Table
　
 P
 P-R
 R
 R-N
 N
 N-D
 D
Signal "1"
 12V
 12V
 0
 0
 0
 0
 0
Signal "2"
 0
 12V
 12V
 12V
 0
 0
 0
Signal "3"
 0
 0
 0
 12V
 12V
 12V
 0
Signal "4"
 0
 0
 0
 0
 0
 12V
 12V

Circuit Diagram
...

Removal
1. Place the shift lever into the "N" position. 2. Remove the air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

See also:

Special driving conditions
Hazardous driving conditions When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra ...

IMS Power Seat Control Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Specifications
Direct control VFS[35R/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current value(mA) ...

Categories

Copyright www.ksmanual.com 2014-2026