Kia Sorento: Output Speed Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Output Speed Sensor Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Output Speed Sensor Removal

1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A).
3.
Remove the input & output speed sensor (B) after removing the bolts (2ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Output Speed Sensor Installation
1. Install in the reverse order of removal.    • ...

See also:

Circuit Diagram
...

Emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If you ha ...

Inspection
[Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied ...

Copyright www.ksmanual.com 2014-2026