Symptoms
|
Possible Causes
|
Remedy
|
Coolant leakage
|
| • |
From the bleed hole of the water pump
|
|
Visually check
|
| • |
Check leaks after about ten-minute warming up.
|
|
| • |
If coolant still leaks, replace a water pump.
|
|
| • |
If leakage stops, reuse the water pump (Do not replace the pump
with a new one).
|
|
|
|
| • |
Check the tightening of the water pump mounting bolts.
|
|
| • |
Retighten the mounting bolts.
|
|
| • |
Check damage of gaskets or inflow of dust.
|
|
| • |
Replace the gasket and clean dust off.
|
|
| • |
From outer surface of water pump
|
|
| • |
Check the material or any cracks of the water pump.
|
|
| • |
Poor material. If any crack found, replace the water pump.
|
|
Noise
|
|
Inspection with a stethoscope
|
| • |
After starting the engine, check noise with a stethoscope.
|
|
| • |
If there is no noise, reuse the water pump(do not replace it).
|
|
| • |
If there is any noise from the water pump, remove the drive
belt and recheck.
|
|
Inspection after removing a drive belt
|
| • |
After removing a water pump and a drive belt, check noise again.
|
|
| • |
If there is noise, reuse the water pump. Check other drive line
parts.
|
|
| • |
If there is no noise, replace the water pump with a new one.
|
|
Inspection after removing a water pump
|
| • |
After removing a water pump and a drive belt, check noise again.
|
|
| • |
If there is any interference between them, replace the water
pump with a new one.
|
|
Overheating
|
|
Loosened impeller
|
| • |
Corrosion of the impeller wing
|
|
| • |
Poor coolant quality / Maintenance check
|
|
| • |
Impeller seperation from the shaft
|
|
| • |
Replace the water pump.
|
|
See also:
Schematic Diagram
Canister
Canister is filled with charcoal and absorbs evaporated vapor in fuel
tank. The gathered fuel vapor in canister is drawn into the intake manifold
by the ECM/PCM when appropri ...
Components Location
1. AVN (A/V & Navigation) head unit
2. Tweeter speaker
3. External amplifier
4. Roof antenna (Radio+Sirius+GPS)
5. Front door speaker
6. Rear door speaker
7. Subwo ...
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle ...