Kia Sorento: Water pump Inspection - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Water pump Inspection

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Mechanical System / Cooling System / Water pump Inspection

1.
Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary.
2.
Check the bearing for damage, abnormal noise and sluggish rotation, and replace the coolant pump assembly if necessary.
3.
Check for coolant leakage. If coolant leaks from hole, the seal is defective.
Replace the coolant pump assembly.
  
A small amount of "weeping" from the bleed hole is normal.
Water pump Removal and Installation
1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the dr ...

Water pump Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole of the water pump Visually check ...

See also:

Input Speed Sensor Removal
1. Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body") 2. Disconnect the input & output speed senso ...

Heated Oxygen Sensor (HO2S)
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...

Compressor Oil Specification
1. The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. ...

Copyright © www.ksmanual.com 2014-2019