Kia Sorento: Water Temperature Control Assembly Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Loosen the drain plug and drain the engine coolant.
|
| 3. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator")
|
| 4. |
Disconnect the connectors and then remove the wiring protector (A).
|
| 5. |
Disconnect the E.T.C cooler hose (A) and the remove the water temperature
control assembly(A).
|
| 6. |
Install in the reverse order of removal.
|
Water Temperature Control Assembly Components
1. O-ring
2. Water temperature control assembly
3. Water inlet fitting
4. Engine coolant temperature sensor
5. Thermostat
6. Thermostat gasket
7. Oil cooler coolant ho ...
Thermostat Removal and Installation
Removal of the thermostat would have an adverse effect, causing a lowering
of cooling efficiency. Do not remove the ther ...
See also:
Engine Mounting Components
1. Transaxle mounting bracket
2. Roll rod bracket
3. Engine mounting bracket
4. Engine mounting support bracket
...
Air bag
(1) Driver’s front air bag
(2) Passenger’s front air bag
(3) Side air bag
(4) Curtain air bag
WARNING
Even in vehicles with air bags, you and your passengers must always wear the
safety be ...
Schematic Diagrams
Circuit Diagram - ESC (1)
Circuit Diagram - ESC (2)
Circuit Diagram - ESC (3)
Circuit Diagram - ESC (4)
ESC connector input/output
Connector Terminal
Specifica ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026