Kia Sorento: Blower

Auto Defogging Actuator Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the cowl side trim. (Refer to Body - "Crash Pad") ...

Blower Unit Components

1. Intake Case (LH) 2. Intake Case (RH) 3. Intake Door 4. Cowl Seal 5. NVH Seal 6. Blower Upper Case 7. Cluster Ionizer 8. Blower Lower Case 9. Power Mosfet (DAT ...

See also:

Installation
   • Install the component with the specified torques. • ...

Rail Pressure Sensor (RPS)
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor ...

Inspection
Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TP ...