Kia Sorento: PTG Spindle Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Power Tailgate Module / PTG Spindle Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the tailgate trim and Luggage side trim.
(Refer to the Body - "Tailgate")
|
| 3. |
Disconnect the power PTG spindle connector (A).
|
| 4. |
Using a screwdriver (A), lift up slightly the socket clips (B)
of both ends on the lifer (D), and then remove the PTG spindle from
the bracket (C).
|
| 5. |
If it is necessary, remove the nuts and replace the PTG spindle
bracket (A).
|
Anti-Pinch Strip Installation
1.
Install the tailgate anti-pinch strip.
2.
Install the tailgate side trim.
3.
Connect the negative (-) batter ...
PTG Spindle Installation
1.
Connect the PTG spindle, bracket and connector.
Tightening torque :
6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0 lb-ft)
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS)
35R Clutch control solenoid valve(35R/C) is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R Clutch.
...
Parking Brake Cable Removal
Parking brake pedal Type
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lo ...
IMS Power Seat Control Installation
1.
Install the power seat control switch after connecting the connector.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026