Kia Sorento: Wiper Arm Repair Procedures
|
•
|
After IG off, move the wiper switch to the single wiping (MIST) position within 20 seconds and hold
the switch more than 2 seconds until the wiper blade is in the service position.
|
|
•
|
After IG ON, move the wiper switch to the single wiping (MIST) and wiper arms will return to the
normal operating position.
|
|
| 1. |
If necessary, remove the blade by pushing it in the direction arrow after opening the hook (A).
|
| 2. |
Remove the wiper arms (A) by removing the nuts after removing the caps.
Tightening torque :
22.6 - 26.5 N·m (2.3 - 2.7 kgf·m, 16.6 - 19.5 lb·ft)
|
|
Rear Wiper Arm
|
•
|
After IG off, move the wiper switch to the single wiping (MIST) position within 20 seconds and hold
the switch more than 2 seconds until the wiper blade is in the service position.
|
|
•
|
After IG ON, move the wiper switch to the single wiping (MIST) and wiper arms will return to the
normal operating position.
|
|
| 1. |
If necessary, remove the blade by pushing it in the direction arrow after opening the hook (A).
|
| 2. |
Remove the rear wiper arm (A) after removing the nut.
Tightening torque :
8.8 - 12.7 N·m (0.9 - 1.3 kgf·m, 6.5 - 9.4 lb·ft)
|
|
| 1. |
Install in the reverse order of removal.
|
•
|
When installing, place the wiper arm to the specified position and then tighten the nut.
|
[Front Wiper]
(Passenger)
|
–
|
Place the wipers to the marking (A) position of cowl top cover.
|
(Driver Side)
|
–
|
Place the wipers to the marking (A) position of windshield glass.
|
[Rear Wiper]
|
–
|
Wiper blade to be lined up on marking (A).
|
|
|
Inspection
Washer Motor
1.
Before filling the reservoir tank with water, check the filter for foreign material or contamination.
→ Clean th...
Removal
Front Wiper Motor
1.
Disconnect the battery negative ( - ) terminal.
2.
...
See also:
Description
An inverter is a device that transforms the DC voltage from the battery
into an AC voltage (115 V). The inverter can power various electrical devices
that consume 150 W or less, including mob ...
Exhaust Manifold Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Disconnect the front oxygen sensor ...
Repair procedures
A/S Repair produres
[C-MDPS]
C-MDPS System A/S Workflow
Noise / malfunction Inspection
...
Washer Motor Repair Procedures
Wiper Motor Repair Procedures
