Kia Optima Manuals

Kia Sorento: Valve Body Installation - Hydraulic System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Valve Body Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body Installation

1.
Install in the reverse order of removal.
  
•
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Valve Body Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

ATF Warmer Description
The ATF warmer is mounted on the valve body cover to reduce oil viscosity friction by increasing oil temperature under cold condition, which in turn improves fuel efficiency. It is serial mou ...

See also:

Wheel Hub nut tightening sequence
Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)    ...

Cup holder
WARNING - Hot liquids Do not place uncovered cups with hot liquid in the cup holder while the vehicle is in motion. If the hot liquid spills, you may burn yourself. Such a burn to the driver c ...

3. TCM Terminal input/ output signal
Connector [A] Pin No. Signal Condition Type Level 29 Sports mode up switch Up ON Input 0V/Battery voltage level ...

Categories

Copyright www.ksmanual.com 2014-2026