Kia Sorento: ATF Warmer Description
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Hydraulic System / ATF Warmer Description
The ATF warmer is mounted on the valve body cover to reduce oil viscosity
friction by increasing oil temperature under cold condition, which in turn improves
fuel efficiency. It is serial mounted on the entry of the Electronic Throttle
Controller (ETC), as shown in the diagram, and minimizes the effects of cabin
heating system.
| - |
Engine coolant is used for circulating heat in order to heat and
cool the transaxle oil.
|
| - |
Rapidly elevates the transaxle oil temperature during the initial
cold start of the engine.
|
| - |
Prevents over heating of the transaxle oil while the vehicle is
moving.
|
| - |
Transaxle oil warm-up and cooling can be done with a single system.
|
| - |
The water coolant and oil are separate in order to exchange heat.
|
Valve Body Installation
1.
Install in the reverse order of removal.
•
...
ATF Warmer Component Location
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...
See also:
Hazard Lamp Switch Installation
1.
Install the heater control unit to the center fascia panel.
2.
Install the center fascia panel.
...
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Description
Windshield deicer system prevent windshield wiper from freezing in the
winter season. It consists of deicer in the lower part of windshield, switch
and relay. Body control module receives an ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026