Kia Sorento: Blind Spot Detection Unit Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear bumper. (Refer to Body - "Rear Bumper")

3.

Remove the BSD unit (A) after loosening the mounting screws.

Take care not to separate the bracket from rear bumper when removing the BSD sensor.

Blind Spot Detection Unit Circuit Diagram

...

Blind Spot Detection Unit Installation

1. Install the BSD units to the rear bumper. 2. Install the rear bumper. 3. Connect the negative (-) battery te ...

See also:

Trouble Symptom Charts
Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surgin ...

Description
Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the a ...

Anti-Pinch Strip Installation
1. Install the tailgate anti-pinch strip. 2. Install the tailgate side trim. 3. Connect the negative (-) batter ...

Categories

Copyright © www.ksmanual.com 2014-2025