Kia Sorento: SRS Control Module (SRSCM) Removal - SRSCM - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: SRS Control Module (SRSCM) Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Removal

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console.
(Refer to Body - "Floor console")
4.
Loosen the bolts and then remove the rear air vent duct (A).

5.
Pull up the lock of the SRSCM connector, the disconnect the connector (A).

6.
Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove the SRSCM.
  
You must remove or install SRSCM or other SRS components with the ignition swich OFF to avoid accidental airbag deployment.
SRS Control Module (SRSCM) Components
...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

See also:

Condenser Inspection
1. Check the condenser fins for clogging and damage. If clogged, clean them with water, and blow them with compressed air. If bent, gently bend them using a screwdrive ...

Component Location
[Engine Room] 1. Receiver-drier 2. Condenser 3. Ambient temperature Sensor 4. Compressor 5. Discharge Hose 6. Suction & Liquid Tube Assembly 7. Servic ...

[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Copyright www.ksmanual.com 2014-2026