Kia Sorento: SRS Control Module (SRSCM) Installation - SRSCM - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: SRS Control Module (SRSCM) Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Install the SRSCM with the SRSCM mounting bolts.

Tightening torque :
8.0 ~ 12.0 N.m (0.8 ~ 1.2 kgf.m, 5.9 ~ 8.9 lb-ft)

  
Use new mounting bolts when replacing the SRSCMafter a collision.
4.
Connect the SRSCM harness connector.
5.
Install the rear air vent duct and floor console.
(Refer to Body - "Floor console")
6.
Reconnect the battery negative cable.
7.
After installing the SRSCM, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
  
SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able to expanse if mechanic moves the SRSCM on vehicle during IGN ON state. For this reason, turn the IGN OFF surely and then remove the SRSCM from vehicle.
If the SRSCM is replaced always perform variant coding. Also, perform the lateral G sensor 0 point setup.
(Refer to Brake System – “Yaw-rate and Lateral G Sensor”)
SRS Control Module (SRSCM) Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding” procedure.    1. ...

See also:

Power Door Mirror Switch Inspection
1. Remove the front door trim and power door mirror switch module (A). (Refer to Body - "Front door") 2. Check fo ...

Tire pressure monitoring system  TPMS
(1) Low tire pressure telltale / TPMS malfunction indicator Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by ...

Crankshaft Reassembly
1. Install the main bearings.    Upper bearings have an oil groove of oil ho ...

Copyright www.ksmanual.com 2014-2026