1. |
Disconnect the IMS control switch connector.
|
2. |
With the power IMS control switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the IMS control switch.
|
3. TCM Terminal input/ output signal
Connector [A]
Pin No.
Signal
Condition
Type
Level
29
Sports mode up switch
Up ON
Input
0V/Battery voltage level
...
AC Inverter Switch Removal
•
Pry the trim off using a plastic trim tool and apply protective
tape around the rela ...
Catalytic Converter Installation
1.
Install in the reverse order of removal.
...