Kia Sorento: Side Impact Sensor (SIS) Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Removal

Front Side Impact Sensor

â€¢	Removal of the airbag must be performed according to the precautions/procedures described previously.

â€¢	Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).

â€¢	Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front door trim. (Refer to the Body group- Front door)

3.	Disconnect the front side impact sensor connector and remove the front side impact sensor mounting screws.

Rear Side Impact Sensor

1.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

2.	Remove the rear seat. (Refer to the Body group- Seat)

3.	Remove the luggage side trim. (Refer to the Body group - Interior trim)

4.	Disconnect the rear side impact sensor connector.

5.	Loosen the rear side impact sensor mounting bolt and remove the rear side impact sensor.

Side Impact Sensor (SIS) Components

...

Side Impact Sensor (SIS) Installation

Front Side Impact Sensor â€¢ Do not turn the ignition switch ON and do not connect ...

See also:

Front Strut Assembly Disassembly
1. Remove the dust cover(A). 2. Using the special tool (09546-26000), compress the coil spring (A). 3. ...

Rear Cross Member
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

Categories

Copyright © www.ksmanual.com 2014-2026