Kia Sorento: Smart key unit Installation - Smart key System - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Smart key unit Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Smart key System / Smart key unit Installation

Smart Key Unit
1.
Install the smart key unit.
2.
Install the smart key unit mounting bolt and nut, and then connect the connector.
3.
Install the glove box.
4.
Install the negative (-) battery terminal and check the smart key system.
Interior 1 Antenna
1.
Install the interior 1 antenna.
2.
Install the console assembly.
3.
Install the negative (-) battery terminal and check the smart key system.
Interior 2 Antenna
1.
Install the interior 2 antenna.
2.
Install the connector mounting bracket.
3.
Install the console rear cover after connecting the connector.
4.
Install the negative (-) battery terminal and check the smart key system.
Interior 3 Antenna
1.
Install the interior 3 antenna.
2.
Install the third seat assembly.
3.
Install the negative (-) battery terminal and check the smart key system.
Exterior Bumper Antenna
1.
Install the exterior bumper antenna.
2.
Install the rear bumper.
3.
Install the negative (-) battery terminal and check the smart key system.
Buzzer
1.
Install the buzzer.
2.
Install the front left wheel guide.
3.
Install the negative (-) battery terminal and check the smart key system.
Door Outside Handle
1.
Install the outside handle.
2.
Install the door trim.
3.
Install the negative (-) battery terminal and check the smart key system.
Tailgate Switch
1.
Install the tailgate switch.
2.
Install the tailgate garnish.
3.
Install the tailgate trim.
4.
Install the negative (-) battery terminal and check the smart key system.
Smart key unit Inspection
Smart Key Unit - Refer to BE group - inspection / self diagnosis with scan tool. Smart Key Switch - Refer to BE group - inspection / self diag ...

Smart Key Diagnostic Inspection
Self Diagnosis With GDS Smart key system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. The following thr ...

See also:

Component Location
1. Smart key unit 2. Door handle & door antenna 3. Interior antenna 2 4. Interior antenna 3 5. Tailgate switch 6. Bumper antenna 7. FOB key 8. IPM (Intelligent ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

Panorama Sunroof Adjustment
Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. ...

Copyright www.ksmanual.com 2014-2026