Kia Sorento: Removal - Inhibitor Switch - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2022 Service ManualKia Sorento: Removal

Second Generation XM (2011-2022) / Kia Sorento XM 2011-2022 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch / Removal

1.
Place the shift lever into the "N" position.
2.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
4.
Disconnect the inhibitor switch connector (A).

5.
Remove the shift cable mounting nut (A).

6.
Remove the manual control lever (B) and the washer after removing a nut (A).

7.
Remove the inhibitor switch (A) after removing the bolts (2ea).

Inspection
   • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contam ...

Installation
1. Check that the shift lever is placed in the "N" position 2. Install the inhibitor switch (A). ...

See also:

Sensors
The sensors are located as follows. Interior air temperature sensor Solar sensor The automatic climate control system employs several sensors. These sensors are delicate. If they are not treate ...

Troubleshooting
Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywhe ...

Setup
Display Settings Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up]   Changes selection mode During On state, pr ...

Copyright © www.ksmanual.com 2014-2022