Kia Sorento: Installation - SS-B Solenoid Valve(ON/OFF) - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-B Solenoid Valve(ON/OFF) / Installation

1.
Install in the reverse order of removal.
  
•
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
•
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

Inhibitor Switch
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used to control gear setting signals. ...

See also:

Rear Door Components
1. Door inside handle cap 2. Door trim 3. Door belt inner weatherstrip 4. Door module 5. Door panel 6. Door belt weatherstrip 7. Door body side weatherstrip 8. Door ...

Special Service Tools
Tool(Number and Name) Illustration Use 09495-3K000 Band installer Installation of ear type boot band 09568-4A000 Ball joint ...

4WD ECU Removal
1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool. (Refer to 4WD Control System - "Repair procedures") ...

Copyright © www.ksmanual.com 2014-2023