Kia Sorento: Installation
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply the engine coolant to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
|
| •
|
Supplement the engine coolant. (Refer to Engine Mechanical
System - "Coolant")
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
See also:
Description
BSD is a system that uses two magnetic wave radar sensors attached on
the rear bumper to measure the distance from the following vehicles and provides
the sensing and (visual and auditory) al ...
Front Washer Motor Installation
1.
Reassemble the washer reservoir.
Before installing the pump motor, che ...
Under Body (2WD)
Projected Dimensions
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Actual-Measurement Dimensions
...
Removal
