Kia Optima Manuals

Kia Sorento: Removal - Manifold Absolute Pressure Sensor (MAPS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor from the surge tank.
Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Spe ...

Installation
   • Install the component with the specified torques. • ...

See also:

Under Body (4WD)
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions ...

Pressure Sensor Installation
   • Check the cleanliness of the pressure sensor before installation. ...

Signal Waveform
...

Categories

Copyright www.ksmanual.com 2014-2025