Kia Sorento: Rear Stabilizer Bar Inspection

Rear Stabilizer Bar Removal

1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Rear Cross Member Replacement

1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

See also:

Heated Oxygen Sensor (HO2S)
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...

Power Seat Control Switch Installation
1. Install the power seat control switch after connecting the connector. ...

Direct Electro Hydraulic Actuator Coupling Inspection
   All units are filled up with coupling fluid (ultra-low viscosity ATF) prior to shipping. Inspection, fill-up, and replac ...