Kia Sorento: Rear Seat Back Cover Repair Procedures
Kia Sorento (MQ4, 2021-2026) Service Manual / Body (Interior and Exterior) / Seat (Rear) / Rear Seat Back Cover Repair Procedures
| Removal and Installation |
| 2nd Seat Back Cover |
[5/7 SEAT]
[LH]
| 1. |
Remove the 2nd seat assembly [LH].
(Refer to Seat (Rear) - "Rear Seat Assembly")
|
| 2. |
Remove the rear back armrest cap.
|
| 3. |
Remove the rear back armrest (A) after removing the screw.
|
| 4. |
Remove the headrest by pressing the locking pin.
|
| 5. |
Remove the rear seat belt center cover (A) using a screwdriver or remover.
|
| 6. |
Remove the second row seat child anchor cover (A) by using a flat-head screwdriver or remover.
|
| 7. |
Remove the protector (A) by using a remover.
|
| 8. |
Remove the hog ring clips (A).
|
| 9. |
Remove the second row seat strap cover(A) by using a flat-head screwdriver or remover.
|
| 10. |
Remove the rear screw of the 2nd seat back armrest cover.
|
| 11. |
Remove the second row seat inner shield cover (A) by removing the mounting screw.
|
| 12. |
Remove the second row seat back armrest bracket (A) by removing the mounting bolt and nuts.
|
| 13. |
Remove the second row seat back lower armrest pad (A).
|
| 14. |
Remove the second row seat back armrest panel (A) by removing the mounting screws.
|
| 15. |
Remove the second row seat recliner lever cap (A). by using a flat-head screwdriver or remover.
|
| 16. |
Remove the second row seat recliner lever (A) removing the mounting bolt.
|
| 17. |
Remove the second row seat outer shield cover (A) by removing the mounting screw.
|
| 18. |
Remove the rear center seat belt lower anchor bolt at the bottom of the second row seat cushion [LH]side.
|
| 19. |
Remove the headrest guide (A) by pressing the lock pin (B).
|
| 20. |
Disconnect the 2nd seat heating connector (A).
|
| 21. |
Remove the second row seat back assembly (A) by from the second row seat back frame.
|
| 22. |
Remove the aplix tape (A) and the hog ring clip (B) from inside the second row seat back cover.
|
| 23. |
Remove the second row seat back cover (A) from the second row seat back pad.
|
| 24. |
Install in the reverse order of removal.
|
[RH]
| 1. |
Remove the 2nd seat assembly [RH].
(Refer to Seat (Rear) - "Rear Seat Assembly")
|
| 2. |
Remove the headrest by pressing the locking pin.
|
| 3. |
Remove the second row seat child anchor cover (A) by using a flat-head screwdriver or remover.
|
| 4. |
Remove the protector (A) by using a remover.
|
| 5. |
Remove the second row seat strap cover(A) by using a flat-head screwdriver or remover.
|
| 6. |
Remove the hog ring clips (A).
|
| 7. |
Remove the second row seat recliner lever cap (A). by using a flat-head screwdriver or remover.
|
| 8. |
Remove the second row seat recliner lever (A) by removing the mounting bolt.
|
| 9. |
Remove the second row outer shield cover (A) by removing the mounting screw.
|
| 10. |
Remove the second row seat inner shield cover (A) by removing the mounting screw.
|
| 11. |
Disconnect the 2nd seat heating wire connector (A).
|
| 12. |
Remove the headrest guide (A) by pressing the lock pin (B).
|
| 13. |
Remove the second row seat back assembly (A) by from the second row seat back frame.
|
| 14. |
Remove the aplix tape (A) and the hog ring clip (B) from inside the second row seat back cover.
|
| 15. |
Remove the second row seat back cover (A) from the second row seat back pad.
|
| 16. |
Install in the reverse order of removal.
|
[6P]
| 1. |
Remove the 2nd seat assembly.
(Refer to Seat (Rear) - "Rear Seat Assembly")
|
| 2. |
Remove the rear seat headrest (A).
|
| 3. |
Remove the headrest guides (A) by pulling upward.
|
| 4. |
Remove the rear seat folding switch (A).
|
| 5. |
Disconnect the rear seat folding switch connector (A).
|
| 6. |
Remove the rear seat armrest cap (A).
|
| 7. |
Remove the second row seat armrest (A) by removing the mounting bolt.
|
| 8. |
Remove the tether bezel (A).
|
| 9. |
Remove the rear seat back protector (A).
|
| 10. |
Remove the rear seat back hog ring clips (A).
|
| 11. |
Remove the rear seat back protectors (A).
|
| 12. |
Disconnect the rear seat heater connector (A).
|
| 13. |
Remove the rear seat back protectors (A).
|
| 14. |
Remove the rear seat airbag protector (A).
|
| 15. |
Remove the rear seat back cover assembly (A).
|
| 16. |
Remove the Velcro tapes (A) and the hog ring clips (B).
|
| 17. |
Remove the second row seat back cover (A) from the second row seat back pad.
|
| 18. |
Install in the reverse order of removal.
|
| [3rd Seat Back Cover] |
[6/7P]
| 1. |
Remove the 3rd seat assembly.
(Refer to Seat (Rear) - "Rear Seat Assembly")
|
| 2. |
Press the lock pin (A) and removing the third row seat headrest (B).
|
| 3. |
Remove the second row seat child anchor cover (A) by using a flat-head screwdriver or remover.
|
| 4. |
Remove the protector (A) by using a remover.
|
| 5. |
Open the zipper (A) on the side of the third row seat back.
|
| 6. |
Remove the 3rd seat strap cover (A).
|
| 7. |
Remove the third row seat strap cover mounting clips.
|
| 8. |
Remove the back board (A) by removing the mounting screws.
|
| 9. |
Put the third row seat seat strap cover (A) in the direction of the arrow.
|
| 10. |
Press the lock pin (A) and removing the second row seat headrest guide (B).
|
| 11. |
Remove the third row seat back assembly (A) by from the third row seat back frame.
|
| 12. |
Remove the velcro tape (A) and the hog ring clip (B) from inside the third row seat back cover.
|
| 13. |
Remove the third row seat back cover (A) from the third row seat back pad.
|
| 14. |
Install in the reverse order of removal.
|
Removal and Installation
2nd Seat Assembly
[5/7]
1.
Disconnect the battery negative ( - ) terminal.
...
Rear Seat Assembly Repair Procedures
Removal and Installation
[2nd Seat Cushion Cover]
[5/7P]
[LH]
1.
Remove the 2nd seat assembly [LH].
(Refer to ...
Rear Seat Cushion Cover Repair Procedures
See also:
Brake Pedal Components
1. Cowl bracket
2. Brake pedal member assembly
3. Stop lamp switch
4. Brake pedal arm
5. Brake pedal pad
...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Alternator Specifications
Specification
Item
Specification
Rated voltage (V, A)
13.5, 150
Speed in use (r ...
Manuals list
- Kia Sorento MQ4 2021-2026 Owners Manual
- Kia Sorento XM 2011-2015 Owners Manual
- Kia Sorento XM 2011-2015 Service Manual
Copyright © www.ksmanual.com 2014-2026 - 0.0569