Kia Sorento: Rear combination lamp Installation

Rear combination lamp Removal

1. Disconnect the negative (-) battery terminal. [Outside] 2. Loose the screws (2EA) holding the rear combination lamp then disconn ...

Troubleshooting

Symptom Possible cause Remedy One lamp does not light (all exterior) Bulb burned out Replace bulb Socket, wiring or ground faulty ...

See also:

Tilt and telescopic steering
Tilt and telescopic steering allows you to adjust the steering wheel before you drive.You can also raise it to give your legs more room when you exit and enter the vehicle. The steering wheel shoul ...

Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver and pass ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...