Kia Sorento: Rear Blower Resister Inspection - Rear Air Conditioner - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Rear Blower Resister Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Resister Inspection

1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Rear Blower Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recover/recycling/charging station. 3. ...

Rear Blower Resister Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the rear luggage side trim. (Refer to Body - "Interior Trim") ...

See also:

Engine start/stop button
Illuminated Engine Start/Stop button Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the do ...

Rear Disc Brake Inspection
Rear Brake Disc Thickness Check 1. Check the brake pads for wear and fade. 2. Check the brake disc for damage and cracks. ...

Side air bag
Your vehicle is equipped with a side air bag in each front seat. The purpose of the air bag is to provide the vehicle's driver and/or the front passenger with additional protection than that o ...

Copyright www.ksmanual.com 2014-2026