Kia Sorento: Rear Blower Resister Replacement - Rear Air Conditioner - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Rear Blower Resister Replacement

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Resister Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
3.
Remove the rear blower resistor (A) after loosening the mounting screws.

4.
Install in the reverse order of removal.
Rear Blower Resister Inspection
1. Measure terminal-to-terminal resistance of the blower resistor. 2. If the measured resistance is not within specification, the blower re ...

Controller
...

See also:

Power Seat Control Switch Installation
1. Install the power seat control switch after connecting the connector. ...

Radiator Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. 2. Ap ...

Steering Column and Shaft Disassembly
Universal joint assembly 1. Loosen the bolt (A) and then disconnect the universal joint assembly from the steering column assembly. Tightenin ...

Copyright В© www.ksmanual.com 2014-2025