1. |
Disconnect the negative (-) battery terminal.
|
2. |
Recover the refrigerant with a recover/recycling/charging station.
|
3. |
When the engine is cool, drain the engine coolant from the radiator.
|
4. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
5. |
Remove the blower motor (B) after disconnecting the blower motor
connector (A) and loosening the mounting screws.
|
6. |
Install in the reverse order of removal.
|
Crash Pad Components
1. Main crash pad assembly
2. Crash pad side cover [LH]
3. Crash pad side cover [RH]
4. Center fascia panel
5. Crash pad lower panel
6. Reinforce panel
...
Circuit Diagram
...
Evaporator Temperature Sensor Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure resistan ...