1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Remove the sprit pin and castle nut or bolt and then disconnect
the rear assist arm (A) from the rear axle.
[2WD]
[4WD]
|
3. |
Loosen the bolt & nut and then remove the rear assist arm (A)
with the sub frame.
[2WD]
[4WD]
|
4. |
Installation is the reverse of removal.
|
Positive Crankcase Ventilation (PCV) Valve Operation Principle
...
Head Lamps Component (2)
1. Head lamp assembly
2. Head lamp high beam bulb
3. Head lamp low beam bulb (HID & ignitor)
4. Dust cap
5. Turn signal lamp socket & bulb
...
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...