1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Disconnect the solenoid valve connector (A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
ICM Relay Box Description
The ICM relay is united with rear wiper relay, rear blower relay, rear
seat warmer relay (LH/RH), two turn unlock relay and tailgate latch relay which
installed inside the lower crash pad.
...
Passenger Airbag (PAB) Module Removal
1.
Disconnect the battery negative cable and wait for at least thirty
seconds before beginning work.
2.
Remove the glove box housing.
...
Instrument panel overview
1. Audio remote control buttons
2. Driver’s front air bag
3. Horn
4. Instrument cluster
5. Wiper and washer control lever
6. Ignition switch or Engine start/stop button
7. Cruise control but ...