Kia Sorento: Quarter Fixed Glass Removal
| •
|
Put on gloves to protect your hands.
|
| •
|
Take care not to body surface and other parts.
|
|
|
1. |
Remove the following parts.
| A. |
Second row seat assembly
|
| B. |
Third row seat assembly
|
|
|
2. |
Loosen the quarter fixed glass (A) mounting nut.
Tightening torque :
5.9 ~6.4N.m (0.6~0.65Kgf.m, 4.3~4.7lb-ft)
|
|
|
3. |
Cut out the sealant using the sealant cutting tool (09861-31100).
|
• |
Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper bonding.
|
|
• |
Remove the rubber dam and fastereners from the
body.
|
|
• |
Mask off surrounding surfaces before painting.
|
|
|
|
4. |
Remove the quarter fixed glass.
|
1.
With a knife, scrape the old adhesive smooth to a thickness of
about 2mm (0.08 in.) on the bonding surface around the entire windshield
opening flange :
...
1.
With a putt knife, scrape the old adhesive smooth to a thickness
of about 2mm (0.08 in.) on the bonding surface around the entire quarter
fixed glass flange.
...
See also:
SRS Control Module (SRSCM) Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
ESC Control Module Removal
1.
Turn the ignition switch OFF.
2.
Remove the surge tank. [G3.3 GDI]
(Refer to Engine Mechanical System - "Surge Tank")
...
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input,
the SRSCM activates the warning lamp for a bulb check.
The l ...
Windshield Glass Installtion
Quarter Fixed Glass Installation