1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the purge control solenoid valve connector (A).
|
3. |
Disconnect the vapor hoses (B) from the purge control solenoid
valve.
|
4. |
Remove the valve from the bracket (C) in the direction of the
arrow.
|
Fuel Tank Installation
1.
Install in the reverse order of removal.
Fuel tank band installation
bolt:
44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.6 ~ 43.4 lb-ft)
...
Specification
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35
...
Front Driveshaft Components
1. Front driveshaft (LH)
2. Inner shaft bearing bracket
3. Front driveshaft (RH)
[LH]
1. BJ assembly
2. Clip
3. BJ boot band
4. BJ bo ...