Kia Sorento: Propeller Shaft Removal and Installation - Propeller Shaft Assembly - Driveshaft and axle - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Propeller Shaft Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Driveshaft and axle / Propeller Shaft Assembly / Propeller Shaft Removal and Installation

1.
After making a match mark on the flange yoke and transfer companion, remove the propeller shaft mounting bolts (A).

Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

2.
Remove the center bearing bracket (A) mounting bolts (B-2ea).

Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

3.
After making a match mark on the flange yoke and 4WD coupling companion, remove the propeller shaft mounting bolts (A).

Tightening torque:
49.0 ~ 68.6N.m (5.0 ~ 7.0kgf.m, 36.1 ~ 50.6lb-ft)

  
Do not reuse bolts.

4.
Install in the reverse order of removal.
  
When assembl ying propeller shaft, locate marks on flange yoke and T/M transfer flange to be nearly the same loacation.
Propeller Shaft Components
1. Front propeller shaft 2. Center bearing bracket 3. Rear propeller shaft ...

Differential Carrier Assembly
...

See also:

How to use this manual
We want to help you get the greatest possible driving pleasure from your vehicle. Your Owner’s Manual can assist you in many ways.We strongly recommend that you read the entire manual. In order to ...

Curtain Airbag (CAB) Module Removal
1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the roof trim. (Refer to the ...

Rear Glass Defogger Printed Heater Inspection
   Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply finger pressure on th ...

Copyright www.ksmanual.com 2014-2026