Kia Sorento: Front Wiper Motor Inspection - Windshield Wiper/Washer - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Wiper Motor Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Wiper Motor Inspection

Speed Operation Check
1.
Remove the connector (A) from the wiper motor.

2.
Attach the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 5.
3.
Check that the motor operates at low or high speed as below table.

  
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thotoughlly with clean water.
Front Wiper Motor Installation
1. Install the wiper motor. 2. Install the crank arm. Torque : 12.7-17.6Nm (1.3-1.8, kgf.m, 9.4-13.0 lbf. ...

Front Washer Motor Inspection
Front and Rear Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. &nb ...

See also:

Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating position. The indication of the system's prese ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body - "Rear ...

Power Window Motor Inspection
Front Power Window Motor 1. Remove (-) negative battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door&q ...

Copyright www.ksmanual.com 2014-2026