Kia Sorento: Parking Brake Repair procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Maintenance / Chassis / Parking Brake Repair procedures

Inspection

[Pedal Brake Type]

After disassembling/assembling the caliper body or replacing the caliper, parking brake cable or brake disc, re-adjust the parking brake.

1.	Remove the floor console assembly. (Refer to Body - "Floor Console Assembly")

To fit the cable, follow one of these procedures.

•	Apply a parking brake fully more than 3 times

•	With full operation, hold the parking brake for 1 to 2 hours.

After fitting the cable, adjust the adjustment nut so that the stroke is 5 - 6 notch when operating the pedal at 30kgf.

For the BIR type, adjust the adjustment nut of the lever assembly so that the sum of the O / P lever on the rear caliper side and the stopper (LH / RH) angle is within 3.0 mm (0.11 in).

Maintenance — Chassis / Parking Brake / Repair procedures / Inspection illustration

4.	Make sure that there is no gap between adjustment nut and clip after adjusting the parking brake.

5.	Make sure that the brakes are not drag.

6.	Check whether the wheel operates smoothly.

7.	Perform driving test.

8.	Install the floor console assembly. (Refer to Body - "Floor Console Assembly")

[EPB Type]

1.	Operate the EPB switch to test that power is applied to the switch terminals.

Drive Shafts and Boots Repair procedures

Inspection 1. Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage....

Steering Gear Rack, Linkage and Boots Repair procedures

Repair procedures Steering Wheel Play Inspection 1. Align the steering wheel straight. ...

Kia Sorento: Parking Brake Repair procedures

See also:

Manuals list