Kia Sorento: Panorama Sunroof Motor Replacement
| 1. |
Turn the ignition key to the ON position and then close the panoramaroof
completely.
|
| 2. |
Release the panoramaroof control lever.
|
| 3. |
Press and hold the CLOSE button for more than 10 seconds until
the sunroof has moved slightly.
|
| 4. |
Release the panoramaroof control lever.
|
| 5. |
Press and hold the CLOSE button once again within 5 seconds until
the panorama sunroof do as follows ;
|
| 6. |
Reset procedure of panorama system is finished.
|
| 1. |
The panoramaroof ECU detects the Run- time of motor
|
| 2. |
Motor can be operated continuously for the 1st Run-time(120 ±
10sec.).
|
| 3. |
Motor which is operated continuously stops operating after the
1st Run-time(120 ± 10sec.).
|
| 4. |
And then Motor is not operated for the 1st Cool-time(18 ± 2sec.).
|
| 5. |
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued
motor operation after 1st Cool-time(18 ± 2sec.)
|
| 6. |
Motor which is operated continuously stops operating after the
2nd Run-time(10 ± 2sec.)
|
| 7. |
Motor is not operated for the 2nd Cool-time(18 ± 2sec.).
|
| 8. |
Motor repeats the 2nd Run-time and 2nd Cool-time at the continued
motor operation.
T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
|
Panorama Sunroof Motor Inspection
Roller Blind Motor ReplacementInput/Output Specification
Connector Pin Lay Out
IMS input/output pin information
No
Signal Name
I/O
Contents
Remark
A1
-
-
-
...
Battery Sensor Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the bat ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...