Kia Sorento: Occupant Detection system (ODS) Installation - SRSCM - Restraint - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Occupant Detection system (ODS) Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Restraint / SRSCM / Occupant Detection system (ODS) Installation

1.
Install the ODS equipped seat cushion assembly. (Refer to the Body group- Seat)
2.
Install the front passenger seat assembly.
(Refer to the Body group - seat)
3.
Reconnect the battery negative cable.
4.
After installing the ODS, confirm proper system operation :
A.
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
B.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the ODS does not require suppression and the passenger airbag is enabled.
Occupant Detection system (ODS) Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat ass ...

Circuit Diagram
Circuit Diagram (2) Circuit Diagram (3) ...

See also:

Front Lower Arm Removel
1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Drive Plate Removal and Installation
1. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate ( ...

Rear Disc Brake Replacement
1. Remove the rear wheel & tire. 2. Loosen the guide rod bolt (B) and pivot the caliper (A) up out of the way. ...

Copyright В© www.ksmanual.com 2014-2023