Kia Sorento: Inspection

Circuit Diagram

...

Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body - "Rear ...

See also:

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

Occupant Detection system (ODS) Installation
1. Install the ODS equipped seat cushion assembly. (Refer to the Body group- Seat) 2. Install the front passenger seat assembly. ( ...

Rear Driveshaft Components
1. Tone wheel 2. BJ joint 3. BJ boot 4. BJ boot big part band 5. BJ boot small part band 6. Shaft 7. TJ boot small part band 8. TJ boot big part band 9. TJ boot ...