1. |
Turn the ignition key to the "ON" position.
|
2. |
Cover the forward facing sensor.
|
3. |
Head a light to the rearward looking sensor.
|
4. |
The ECM should be darkened as soon as the rearward looking sensor
detects the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened.
When heading lights to both the forward facing and rearward looking
sensors, the ECM should not be darkened.
|
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts with the specified tightening
order.
...
Under Body (4WD)
Projected Dimensions
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Actual-Measurement Dimensions
...
Fuel Filler Door Open Switch Inspection
1.
Remove the front door trim panel.
(Refer to Body - "Front door")
2.
Disconnect the switch connector (A) from wiring.
...