Kia Sorento: Inspection
| 1. |
Remove the cowl top cover.
(Refer to the wiper)
|
| 2. |
Disconnect the windshield deicer connector (A) from the wiper
motor linkage.
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch ON,
then measure the voltage between the terminals of harness side deicer
connector.
|
Description
Windshield deicer system prevent windshield wiper from freezing in the
winter season. It consists of deicer in the lower part of windshield, switch
and relay. Body control module receives an ...
Windshield Deicer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
...
See also:
Cruise Control Switch Inspection
Measuring Resistance
1.
Disconnect the cruise control switch connector from the control
switch.
2.
Measure resistance between t ...
Body Side Moulding Replacement
Roof mouldingmoulding mouldingReplacement
[General Type]
•
Pry the trim off ...
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026