Kia Optima Manuals

Kia Sorento: Cruise Control Switch Inspection - Cruise Control System - Engine Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Cruise Control Switch Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Electrical System / Cruise Control System / Cruise Control Switch Inspection

Measuring Resistance
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Resistance
CANCEL
 4-5
 0Ω
SET/–
 4-5
 220Ω
RES/+
 4-5
 910Ω
ON/OFF
 3-5
 3900Ω

3.
If not within specification, replace switch.
Measuring Voltage
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Voltage
CANCEL
 4-5
 0V ~ 0.22V
SET/–
 4-5
 1.28V ~ 1.77V
RES/+
 4-5
 2.78V ~ 3.22V
ON/OFF
 3-5
 -

3.
If not within specification, replace switch.38
Cruise Control Switch Installation
1. Install in the reverse order of removal. ...

Emission Control System
...

See also:

Battery Removal
1. Disconnect the battery (-) terminal and (+) terminal (A). 2. Remove the battery mounting bracket (B) and the insulation pad and then rem ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Cl ...

Categories

Copyright www.ksmanual.com 2014-2026