Kia Sorento: IMS Control Switch Installation - IMS (Integrated Memory) - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: IMS Control Switch Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS Control Switch Installation

  
Make sure that the IMS control switch connectors and related connectors are plugged in properly.
Check the IMS control switch operates normally.
1.
Connect the connectors and reassemble the IMS control switch.
2.
Reassemble the front door trim.
IMS Control Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door") ...

IMS Control Switch Inspection
1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity ex ...

See also:

SRSCM Connector terminal
Pin Function (Connector A) Pin Function (Connector B) 1 Ignition 1 Seat belt pretensioner [Driver] High 2 - ...

In-car Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia panel (A). ...

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Copyright В© www.ksmanual.com 2014-2023