Kia Sorento: Heater & A/C Control Unit (Manual) Replacement
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Controller / Heater & A/C Control Unit (Manual) Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or remover, remove the center fascia panel
(A).
|
| 3. |
Disconnect the clock connector (A).
|
| 4. |
Disconnect the heater and A/C controller connectors (A).
|
| 5. |
Remove the heater & A/C controller (A) from the center facia after
loosening the mounting screws.
|
| 6. |
Install in the reverse order of removal.
|
Heater & A/C Control Unit (Manual) Component
Connector Pin Function
Connector
Pin No
Function
Connector
Pin No
Function
A
1
Ground
B
18
IG ...
Heater & A/C Control Unit (DATC) Component
Connector Pin Function
Connector
Pin No
Function
Connector
Pin No
Function
A
1
Battery (+)
A
29
...
See also:
Front Stabilizer Bar Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Fuel Pump Motor Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the fuel sender connector (A).
...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026