1. |
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
|
2. |
Remove the rear seat.
(Refer to Body - “Rear Seat Assembly”)
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure
sensor connector (B).
|
5. |
Disconnect the fuel feed tube quick connector (C) and the vapor
tube quick-connector (D).
|
6. |
Remove locking ring (A) by using the special service tool.
|
7. |
Disconnector the vapor tube quck-connector (A) at the fuel pump,
and then remove the fuel pump from the fuel tank.
|
OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of On Board
Diagnostics (OBD) for vehicles sold in California beginning with the 1988 model
year. The first phase, O ...
Installation
1.
Install in the reverse order of removal.
•
...
Rear Assist Arm Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...