Kia Sorento: Fuel Pump Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump Inspection
[Fuel pump motor]
| 1. |
Turn the ignition switch OFF, and then remove battery (-) cable.
|
| 2. |
Remove the fuel pump assembly.
|
| 3. |
Check motor operation by fuel pump connector (A) connecting power
(No.4) and ground (No.5).
|
[Fuel sender]
| 1. |
Turn the ignition switch OFF, and then remove battery (-) cable.
|
| 2. |
Remove the fuel pump assembly.
|
| 3. |
Using an ohmmeter, measure the resistance between terminals 1
and 3 of sender connector (A) at each float level.
|
| 4. |
Also check that the resistance changes smoothly when the float
is moved from "E" to "F".
|
Fuel Tank Installation
1.
Install in the reverse order of removal.
Fuel tank band installation
bolt:
44.1 ~ 58.8 N.m (4.5 ~ 6.0 kgf.m, 32.6 ~ 43.4 lb-ft)
...
Fuel Pump Removal
1.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release
Residual Pressure in Fuel Line")
...
See also:
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...
Auto Head lamp leveling Unit Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Height sensor signal change
...
Valve Body Installation
1.
Install in the reverse order of removal.
•
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026